INJECTADRY

HP-PLUS Floor Drying Package

The HP-PLUS Package is designed specifically for flooring. The set-up is extremely quick, easy and efficient for your typical floor drying needs. The HP Plus unit does not need pressure relief valves as it uses a VFD (variable frequency drive) to control the rate at which the motor runs. It is set to always run at maximum amperage allowed (12A). This ensures that the unit is providing as much suction or pressure as possible.

• DRYING CAPACITY: 134 linear feet (1 injector every 16”)
• TOTAL SYSTEM AIRFLOW: 120 CFM (cubic feet per minute)
• DRYING MODES: Negatively or Positively
• MOTOR TYPE: 3 Phase, Industrial Regenerative Blower
• POWER DRAW: Power Draw – 115v 15A circuit needed 5.6 – 6.5 amps (no restrictions) | 11 – 12 amps (avg. application.)
• AMPS: Draws less than 12 amps—no matter the setup
• STATIC PRESSURE: (Maximum) 60 inches (water lift) and still has 55 CFM
• WALL INJECTOR DIAMETER: 3/16 inches
• FEATURES: You can use up to 12 Multi-Port or 20 8-Port Vac-It panels with an increase up to 30% in drying capabilities
• No tripping of breakers at startup. Consistent pressures with no pressure relief valves